Welcome to the world of modern retro lighting with our Aaron E27 lampholder. This timeless model embodies the essence of craftsmanship, recalling a time when every detail counted and quality was at the heart of design.
The Aaron lampholder, with its elegant finish, brings a touch of refinement and elegance to any light fitting, blending tradition and modernity for a unique lighting experience.
Made from the noble material of brass, this lampholder captures the essence of the past while blending harmoniously into contemporary interiors.
Features:
E27 lamp holder
M10 thread porcelain base with two-core terminal block, phase and neutral
Material: brass
Body diameter 40 mm
Height 57 mm without cable clamp
Lampshade passage diameter: 40mm
Cable connection by screws
Power rating: 2A - 250V
Maximum power of bulbs: 150 Watts
Weight: 150g
Lampholder sold individually with porcelain lampholder, but without cable clamp
Electrical safety information.
In terms of electrical connectivity, this porcelain lampholder will be installed with wiring including phase and neutral, earthing is possible, a small hole is available on the side of the jumper to connect a small earth cable on a round lug, some pre-wired earth cables are available at the bottom of the product data sheet.
For obvious aesthetic reasons, it is difficult to envisage using a large 230 volt 2P + earth plug or socket for a floor-mounted lamp. More commonly, a flat 2-pin plug is used, allowing only phase and neutral to be connected using a two-conductor cable.
This connection without earthing is possible, but it is essential to use an anti-pull-out system for the cable coming out of the lamp. Various cable locking devices can be installed, either in the base of the lamp or directly in the bottom of the lampholder.
These small plastic mechanisms have an anti-rotation and anti-pull function for your power supply cable.
These cable locks are available in the 'You'll like them too' section at the bottom of the product sheet.
