Horticultural LED strip 230 volts - red and blue LED ratio 4 / 2

Strip LED Horticole 230 volts - LED red and blue ratio 4 / 2 - sold by the linear metre

Horticultural LED Strips combine red and blue LEDs in a 4/2 ratio to guarantee optimum performance for your aeroponics, hydroponics, ultraponics or open-ground crops...

Strip-Horti-4:2
€13.50
Tax included

Description

A horticultural strip with blue LEDs and red LEDs because the photoreceptors in plants only perceive certain specific colours.

The colours orange and yellow are only partially assimilated as red by plants.
The same applies to violet and indigo, these two other colours are only very slightly absorbed as a residual blue colour.

And plants are virtually insensitive to green light because they have no photoreceptor called cryptochrome for this colour.

Horticultural LED strips are made up of two types of monochromeLED - 20 blue LEDs (460nm) for growth and 40 red LEDs (630nm) for flowering. They generate a very precise spectrum and their complementary nature will ensure abundant cultivation!

Rouleau de strip LED horticole start

The light spectrum of the LED strips is almost 98% absorbed by the plants, which means that in an optimum growing configuration, very good yield results will be obtained.

Rouleau de strip LED horticole in

However, despite its excellent IP67 waterproof rating, it cannot be immersed in water, as accidental damage to the strip would be far too dangerous.

Particular attention must be paid to the watertightness of the electrical input connections and the termination plug.

These flexible rollers are protected by an IP67 silicone sealing resin but are not fitted with a self-adhesive strip.
However, a 3M double-sided adhesive is available as an accessory.

Mise en place du câble d'alimentation strip LED

The horticultural LED strips can be cut every 1 metre at specific points.

étagère avec éclairage LED horticole

Product description:
Sold by the linear metre
Number of LEDs: 60 LEDs per metre type 5050 RGB (20 blue 40 red)
Power supply: 85 to 277 volts AC
Brightness: 417.9 Lux at 1 metre
Colour rendering index: 11.9 Ra (CRI)
Power factor: >0.9
Service life: > 50,000 hours
Power consumption: 14 watts / metre
Dimensions: roll length 100 metres max x 12 mm x 5 mm thick
Weight: 120 g per metre
Our products are guaranteed for one year.

Precautions for use :
A special plug-in power supply cable is essential for connecting a 230-volt LED ribbon.
This cable has a small voltage regulator box for 230-volt LED strips and is fitted at the end with a two-pin rapid connector. This accessory is available at the bottom of the product data sheet.

We advise you not to look at the light for long periods, even with protective glasses.

Product Details

You might also like